What Would Happens If You Put R22 In A 410a System
What would happens if you put r22 in a 410a system. In very simple terms you will be back again because using the NEWER R-410A in and OLD R22 system will NOT WORK. What would happens if you put R22 in a 410A system. R-22 uses a polyester oil while R-410A uses a mineral oil so with those mixing I have to imagine that would result in compressor damage plugging orificesTXVsfilter driersetc.
If you add R-22 to an R-134a system you will not get close to the rated cooling capacity of the AC system. It will just flood back to reduce the compressor life and will greatly reduce the system capacity. Id also add suction liquid line driers filler up.
What is the best replacement for r22. All the usual suspects for high head pressure cleared. On Cross contamination saga mixing R22 and 410a.
Putting R-410A refrigerant into an AC unit that was designed to use R-22 will cause the unit to die soon after it tries to run. I would think that if he actually did add R22 to your 410 system that it wouldnt have worked right for 3 months then broke down. If you add R-134a to an R-22 system you will blow the compressor.
Putting R-410A refrigerant into an AC unit that was designed to use R-22 will cause the unit to die soon after it tries to run. Answer 1 of 34. Replacing the condenser compressor evaporator and refrigerant lines.
You cant use an R-410a condenser and an R-22 air handler in the same system when one is using one refrigerant and the other another. With r410a units the installers must have there process dialed in tight. In terms of the air conditioner once you do get somebody there who can evacuate the system and get it fully pulled out the unit should be okay unless you did run it and it had R-22 and R410a refrigerant at the same time.
It will all leak out and make the system unsuitable for R22. Heck you can do a lot of things.
What would happens if you put R22 in a 410A system.
R-22 has been phased out and new air conditioners run on the new R-410A refrigerant which is much more environmentally friendly. What would happens if you put R22 in a 410A system. All the usual suspects for high head pressure cleared. Answer 1 of 34. On Cross contamination saga mixing R22 and 410a. 3 years ago they called out a company to fix what turned out to be a low refrigerant problem on 2 units along with a leak repairs. To make a short story long R410A and R22 are refrigerants. If you add R-22 to an R-134a system you will not get close to the rated cooling capacity of the AC system. That said it isnt unusual to burn ones fingers on a discharge pipe of any system if it is running correctly.
They are both good refrigerants and they both work but they have to be charged in the system at different pressures. It will just flood back to reduce the compressor life and will greatly reduce the system capacity. For the record you should not do any of those. I would think that if he actually did add R22 to your 410 system that it wouldnt have worked right for 3 months then broke down. 3 years ago they called out a company to fix what turned out to be a low refrigerant problem on 2 units along with a leak repairs. Id also add suction liquid line driers filler up. R410A dumped into an R22 system.
Post a Comment for "What Would Happens If You Put R22 In A 410a System"